| Tools |
| |
Administrator Settings
There are only one account that can access
the DSL-G604T's Web-Management interface. It is admin.
Admin has read/write access privilege.
In this web page, you can set new password for admin.
|
| |
Time
The system time is the time used by the DSL-G604T for scheduling
services. You can manually set the time or connect to a NTP (Network Time
Protocol) server. If an NTP server is set, you will need to set the time
zone, you may also set Daylight Saving dates
and the system time will automatically adjust on those
dates. |
| |
Remote Log
Remote Log Server collects the logs sent from our device withcorrect log level.Users can setup the remote log server ip and the log level of our device.Then administrators are able to know the events happened on our device. |
| |
System Settings
The current system settings can be saved as a
file onto the local hard drive. The saved file or any other saved setting
file can be loaded back on the DSL-G604T. To reload a system settings file,
click on Browse to browse the local hard drive and locate the system file
to be used. You may also reset the DSL-G604T back to factory settings by
clicking on Restore.
Save
and Reboot - Settings need to be saved to Flash and the system
needs to be rebooted for changes to take effect.
Restore -
Use this button to restore factory default configuraion.NOTE:Connectivity to the
unit will be lost.You can reconnect after the unit reboots.
Restart AP -
Use this button to restart the Wireless Access Point.It is important to Restart
Access Point any time you change your Wireless settings. |
| |
Firmware Upgrade
You can upgrade the firmware of the DSL-G604T
in this page. Make sure the firmware you want to use is on the local hard
drive of the computer. Click on Browse to browse the local hard drive and
locate the firmware to be used for the update. |
| |
Miscellaneous Item
These are additional tools and features of the
DSL-G604T.
Ping Test - This useful diagnostic utility can be used to check if a
computer is on the internet. It sends ping packets and listens for replies
from the specific host.
IGMP
Proxy - Here is the global setting for IGMP
Proxy. If it is enabled, then the enabled IGMP Porxy on WAN PVCs will be
working. Otherwise, no WAN PVC can have IGMP Proxy working on it.
|
| |
Test
The Diagnostic Test page shows the test results for the
connectivity of the physical layer and protocol layer for both LAN and WAN
sides. |