First Time Setup

Video

How do I setup and install my DAP-1320?

  1. A:
  2. The DAP-1320 cannot be setup by two different methods:

    1. Push button WPS (WiFi Protected Setup)
    2. Manual

    Note: In order to setup the DAP-1320 using WPS, you must have a WPS compatible router/access point


    Push Button WPS

    Step 1: Plug in the DAP-1320

    Note: The light should turn red and then start blinking orange

    User-added image

    Step 2: Press the WPS button on your router/AP

    User-added image

    Step 3: Press and hold the WPS button on the DAP-1320 until it starts blinking green and then release. Once connected, the LED will be solid GREEN.

    User-added image

    Step 4: Unplug and place the DAP-1320 approx half way between the router and the desired connection area.

    User-added image

    Note: To connect wireless to the DAP-1320, use the Wi-Fi Network Name (SSID) and Wi-Fi Password information located on your configuration note.

    User-added image





    Manual Setup

    Step 1: Plug in the DAP-1320

    Note: The light should turn red and then start blinking orange

    User-added image

    Step 2: From a wireless computer/device, scan for available networks and connect to the pre-defined SSID
    (Located on the Companion Card supplied with the DAP-1320 and on the bottom of the DAP-1320) example: Dlink-6DFC .

    User-added image

    Step 3: Open a Web browser and type dlinkap.local. You will be directed to the d-link setup page. Click next to start the setup.

    User-added image

    Step 4: Select the Manual configuration method and click Next.

    The DAP-1320 will scan for available wireless networks. Select the Wi-Fi network you would like the DAP-1320 to extend and click Connect

    User-added image

    Note: If the wireless network you are trying to extend is security enabled, you will be prompted for the WiFi password.

    User-added image

    Step 5: Next you need to create a wireless network name and password for your extended network. It is suggested to configure a name that is different from your "Primary" wireless network.

    Click Next

    User-added image

    Step 6: Confirm your wireless settings and click save

    User-added image

    Setup is now complete. Once the DAP-1320 has applied its settings, its light should be Green and you should not be able to connect to the Extended Wi-Fi Network.






Did you find this article useful? Yes No

Installation Guides