Setup Wizard
The Setup Wizard is a useful and easy utility to help setup the DWL-7000AP to quickly connect to your ISP (Internet Service Provider) with only a few steps required. It will guide you step by step to configure the password, time, and WAN settings of your DWL-7000AP . The Setup Wizard is a helpful guide for first time users to the DWL-7000AP .

Wireless Settings

Allow you to change the wireless settings to fit an existing wireless network or to customize your wireless network.
Service Set Identifier (SSID) is the name designated for a specific wireless local area network (WLAN). The SSID's factory default setting is "default". The SSID can be easily changed to connect to an existing wireless network or to establish a new wireless network.
Indicates the channel setting for the DWL-7000AP . By default the channel for 11g is set to 6, for 11a is set to 36. The Channel can be changed to fit the channel setting for an existing wireless network or to customize the wireless network.

LAN Settings
These are the IP settings of the LAN interface for the DWL-7000AP . These settings may be referred to as Private settings. You may change the LAN IP address if needed. The LAN IP address is private to your internal network and cannot be seen on the Internet. The default IP address is with a subnet mask of You may enter a local domain name for the LAN network if you prefer.
Get IP From
The Access Point is capable of acting as a DHCP server. The DHCP settings can be enabled to allow the Access Point to assign IP addresses to other devices in the wireless local area network.
IP address
The factory default IP address assigned to the D-Link Air DWL-7000AP is The IP address of each device in the wireless local area network must be within the same IP address range and subnet mask. Therefore, each device in the WLAN (wireless local network) must have a unique IP address in the format of 192.168.0.x.
Subnet Mask
Specify the subnet mask for the Access Point. The Subnet mask must be the same for all devices on the same subnet of the network. The default subnet settings for the Access Point is
Specify the gateway IP address for the local network.