| Home |
Setup Wizard
The Setup Wizard is a quick and useful utility to help setup
the to easily connect to your Lan (Local Area Network)
with only a few simple steps. It will guide you step by step to configure
a new password, the SSID, channel, and encryption settings of both 802.11a and 802.11g for the .
The Setup Wizard is a helpful guide for first time users to the .
|
| |
| Wireless Settings |
Allows you to change the wireless settings
to connect to an existing wireless network or to customize your wireless network.
Wireless Band
Select the Wireless Band to configure.
SSID
SSID (Service Set Identifier) is the name designated for a specific
WLAN (Wireless Local Area Network). The SSID's factory default value is set to "default".
The SSID can easily be changed to connect to an existing wireless network
or to establish a new wireless network.
SSID Broadcast
Indicates whether the SSID of your wireless network will be broadcasted.
The default value of SSID Broadcast is set to "Enable", which
allow wireless clients to detect the wireless network. By changing this
setting to "Disable" wireless clients can no longer detect the
wireless network and can only connect if they have the correct SSID entered.
Channel
Indicates the channel setting for the . The default
value for 802.11g is set to 6, and for 802.11a is set to
52.
The Channel can be changed to fit the channel setting for an existing
wireless network or to customize the wireless network.
|
| |
| LAN Settings |
These are the IP settings of the LAN interface
for the . These settings may be referred to as Private settings.
You can change the LAN IP address if needed. The LAN IP address is private
to your internal network and cannot be seen on the Internet. The default
IP address is
192.168.0.50 with a subnet mask of
255.255.255.0.
|
Get IP From
The factory default setting is "Static (Manual)" which allows the
IP address of the to be manually configured in accordance to the
applied local area network. Enable Dynamic (DHCP) to allow the DHCP host to
automatically assign the Access Point an IP address that conforms to the
applied local area network.
IP address
The factory default IP address assigned to the is
192.168.0.50.
The IP address can be changed to conform to an existing local area network.
Please note that the IP address of each device in the wireless local area
network must be within the same IP address range and subnet mask. If the
Access Point IP address remains at the default setting, each device in the
local area network must have a unique IP address in the format of 192.168.0.x.
Subnet Mask
Specify the subnet mask for the Access Point. The Subnet mask must be the
same for all devices on the same subnet of the network. The default subnet
settings for the Access Point is
255.255.255.0.
Gateway
Specify the gateway IP address for the local network.
|
|
|
|