The Network page allows you to configure the IP address of the DWL-810+. Select Dynamic IP to allow the DWL-810+ to receive an IP address automatically from a DHCP server on your network. Any new IP settings change will not taken effect until the DWL-810+ is rebooted. Select Static IP to assign static IP address information to the DWL-810+.

Dynamic IP Address
By selecting Dynamic IP Address for the LAN (Local Area Network) IP, the DWL-810+ will act as a DHCP client and obtain its LAN IP setting from the DHCP (Dynamic Host Configuration Protocol) server in the local network. By default, the DWL-810+ is pre-configured with a Static IP Address of and Subnet Mask of

Static IP Address
The factory default IP Address assigned to the D-Link AirPlus DWL-810+ is The IP Address of each device in the wireless local area network must be within the same IP Address range and subnet mask. For a small subnet with less than 253 IP addresses assigned (e.g. Class C private IP), each device in the WLAN (Wireless Local Area Network) must have a unique IP Address in the format of 192.168.0.x.

Subnet Mask
Specify the subnet mask for the DWL-810+. The Subnet mask must be the same for all devices on the same subnet of the network. The default subnet setting is Keep this default setting if your LAN has an IP address range in the format of 192.168.0.x.

Specify the gateway IP address for the local network. The gateway setting, typically the IP address of a router is required for you to access the Internet or networks outside your LAN (Local Area Network). If you cannot access the Internet or any computer outside your LAN, check your Gateway settings first.