Product Page: WBR-1310 Hardware Version: B1   Firmware Version: 2.02
Setup Advanced Tools Status Support

Network Settings :

Use this section to configure the internal network settings of your router and also to configure the built-in DHCP Server to assign IP addresses to the computers on your network. The IP Address that is configured here is the IP Address that you use to access the Web-based management interface. If you change the IP Address here, you may need to adjust your PC's network settings to access the network again.

Router Settings :

Use this section to configure the internal network settings of your router. The IP Address that is configured here is the IP Address that you use to access the Web-based management interface. If you change the IP Address here, you may need to adjust your PC's network settings to access the network again.

Router IP Address :   
Default Subnet Mask :   
Local Domain Name :  
Enable DNS Relay :  

DHCP Server Settings :

Use this section to configure the built-in DHCP Server to assign IP addresses to the computers on your network.

Enable DHCP Server :
  
DHCP IP Address Range :
    to (addresses within the LAN subnet)
DHCP Lease Time :
   (minutes)

Dynamic DHCP Client List :

Host Name IP Address MAC Address Expired Time
End User192.168.0.11200-04-23-2c-44-9fApr/01/2002 03:00:00
Helpful Hints..

DHCP Server:
If you already have a DHCP server on your network or are using static IP addresses on all the devices on your network, uncheck Enable DHCP Server to disable this feature.

Copyright © 2004-2005 D-Link Systems, Inc.